Welch-allyn ABCs of CVSM 6000 - Quick Reference Guide Instrukcja Użytkownika Pobierz pdf

CVSM 6000 FAQ

MC7719 09/2011

The ABC’s of CVSM 6000

A Age Ranges

To change patient modes, from the screen, touch in bottom left-hand

corner. Touch Type on right side of screen. Choose between Adult, Pediatric, or Neonate. Touch

to save and go back to Home screen. Age ranges are as follows:

• Neonate: 28 days or less if born at term (37 weeks), otherwise up to 44 weeks gestational

age

• Pediatric: 29 days through 12 years

• Adult: > 13 years

B Battery Info

pproximate hours of use:

7–8 hours

6-Cell

9-Cell

Composition

Lithium ion Lithium ion

Charge time to 80%

2 hr 7 min 2 hr 25 min

Charge time to 100%

3 hr 4 hr

Patient exams per charge

26 47

ge to 70% capacity

300 cycles 300

cycles

C Cleaning

Device/Stand

• Disconnect from AC power before cleaning.

• Do not submerge or autoclave monitor or accessories.

The following agents are compatible with the monitor:

• CaviWipes™

• Sani-Cloth

Plus

• 70% isopropyl alcohol

• 10% chlorine bleach

Apply solution to cloth and wipe down monitor; never spray solution directly on monitor.

Allow monitor to dry 10 minutes before use.

Rinse off bleach with a cloth dampened with water.

Note: Disinfect according to your facility’s protocols and standards or local regulations.

Accessories

NIBP hose/reusable cuffs: Wipe down with mild detergent solution.

SpO

Sensor: Wipe with cloth dampened with 70% isopropyl alcohol or 10% chlorine bleach solution.

Temperature probe: Wipe with cloth dampened with alcohol, warm water, or an appropriately diluted,

non-staining disinfectant solution.

D Defaults

To change the default

power on settings:

1. Enter or adjust desired settings. (Note: The new settings appear as they are completed but

are temporary until they are saved.)

2. Touch the Settings tab.

3. Touch the Device tab.

4. Enter or adjust settings you want to add or change. Touch Save as Default.

5. Touch OK to confirm you want to overwrite your previous settings and replace them with

your current settings, or touch Cancel to retain the previous settings.

E End Monitoring

Power Down: From the Home screen, touch the battery icon.

. Touch Power Down.

A patient exam includes NIBP, Temperature, and SpO

measurements at the rate of one patient every 10 minutes with a two-minute display timeout setting and a new battery.

After this many full charge and discharge cycles, the battery has aged to where its total capacity has been reduced to 70% of its rating.

CVSM 6000 FAQ 1
MC7719 09/2011 1

Podsumowanie treści

Strona 1 - MC7719 09/2011

CVSM 6000 FAQ MC7719 09/2011 The ABC’s of CVSM 6000 A Age Ranges To change patient modes, from the screen, touch in bottom left-hand corne

Komentarze do niniejszej Instrukcji

sam 04 Sep 2025 | 15:09:49

good

Welch-allyn ABCs of CVSM 6000 - Quick Reference Guide Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Ekwipunek Welch-allyn ABCs of CVSM 6000 - Quick Reference Guide. Welch Allyn ABCs of CVSM 6000 - Quick Reference Guide User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Welch-allyn ABCs of CVSM 6000 - Quick Reference Guide