Welch Allyn PROPAQ CS Instrukcja Obsługi Pobierz pdf (Strona 101)

Service Manual Repair procedures 97

Opening the SpO

Module

1. Separate the SpO

module from the monitor according to the procedure “Removing

the dual battery in expansion module” on page 66.

2. Two tabs secure the SpO

module rear panel to the SpO

module chassis. Using a

small screwdriver or your finger, press on each of the tabs inside the SpO

module

chassis while applying pressure to separate the rear panel from the chassis. (When

separating the rear panel from the chassis, make sure the side panels remain seated

in the rear panel.)

spo2 chassis disassy

3. After the tabs allow the rear panel to be removed, separate the rear panel from the

chassis.

The rear panel is sealed to the chassis with rubber O-ring gaskets. These gaskets can

be reused when re-assembling the SpO

module.

When closing the SpO

module, confirm that no O-ring gasket slips out of its channel and

becomes pinched between the rear panel and the Chassis.

SpO2 Module

Rear Panel

Release

Tabs

Continuous

O-Ring Gasket

0696-53

Rear

Panel

O-Ring

Cord

Release

Tab (2)

SpO2

Board

SpO2

Connector

Panel

Chassis

Speaker

SCP Board

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 141 142

Komentarze do niniejszej Instrukcji

Brak uwag

Welch Allyn PROPAQ CS Instrukcja Obsługi Strona 101

Komentarze do niniejszej Instrukcji